where is the signing LED code about the Newwork state in zstack

The Seven

there is a ZC and ZED in the network.

when the ZC was working, after ZED join network success, LED1 (P10) will be turn off 。

when ZC power off， the network was close， i find that the LED was flash again and again，when ZC working， the LED1 will be close again。

could you please tell me ，where is this setting about LED flash when there is not network （zstack）？

i want to know how can the ZED judge it before flash the LED，

i want to close this function，and open it when i want！

0 YiKai Chen over 11 years ago

Guru 735695 points

Try to search HalLedSet() and HalLedBlink() in source code and disable them.

0 The Seven over 11 years ago in reply to YiKai Chen

Guru 11440 points

could you please tell me where and how can the ZED judge the network state ？

and i have close all the LED using in APP ，

0 YiKai Chen over 11 years ago in reply to The Seven

Guru 735695 points

It is in ZDO_STATE_CHANGE and you can use zclXXX_NwkState to judge it.

0 The Seven over 11 years ago in reply to YiKai Chen

Guru 11440 points

but i can't fine anything about LED setting in ZDO_STATE_CHANGE, why the ZED flash the LED1 when lose the network？

0 Kyle Zhou over 11 years ago

Expert 1240 points

Please have a look into ZDApp.c

Search for HalLedSet(), HalLedBlink()

I remember only LED 3 & 4 are set.

They are set in Join/Rejoin Confirm call back

Zigbee & Thread forum