how to configure co-ocdinator and end-device using contiki os

karthi gowri

Other Parts Discussed in Thread: CC2530, Z-STACK

hi...

now i have a big problem to implement zigbee network by using contiki OS for CC2530.pls anyone tell how to i configure the end device and co-ordinator in this.atleast i want to communicate with one node.pls anyone help me...

over 11 years ago

0 YiKai Chen over 11 years ago

Guru 735695 points

Implement zigbee network by using contiki OS for CC2530? Z-Stack is only based on TI tiny OS. Why do you need to use Contiki for CC2530 Zigbee?

0 TheDarkSide over 11 years ago in reply to YiKai Chen

TI__Genius 16570 points

Hi,

TI Z-Stack is supported on OSAL on this forum.

ContikiOS port of ZigBee on CC2530 are supported by the Contiki community and not on this forum.

Thanks for your understanding.

TheDarkSide

0 karthi gowri over 11 years ago in reply to YiKai Chen

Prodigy 130 points

thanks for your response...

i want to develop the zigbee networking in CC2530 by using open source IDE.so,i preferred SDCC compiler

with contiki os support.now i implement the codings for onlo one zigbee device.i want to communicate between two cc2530 zigbee devices .For this purpose what can i do?

0 YiKai Chen over 11 years ago in reply to karthi gowri

Guru 735695 points

Since you are using Contiki ZIgbee, you can try to post your problem at http://sourceforge.net/p/contiki/mailman/

0 karthi gowri over 11 years ago in reply to YiKai Chen

Prodigy 130 points

if i want to implement the z-stack in TinyOS means what can i do and how i start the tinyos ?

0 YiKai Chen over 11 years ago in reply to karthi gowri

Guru 735695 points

You can refer to Z-Stack Developer's Guide.pdf and Z-Stack Home Developer's Guide.pdf in Documents folder.

Zigbee & Thread

Zigbee & Thread forum

how to configure co-ocdinator and end-device using contiki os