• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 56 subscribers
  • Views 463 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Reg CC2530 Implementation

AMUDHA GUNASEKARAN1
Genius 3220 points

Other Parts Discussed in Thread: CC2530, SMARTRFTM-STUDIO

sirs,

Any one guide me how to connect external devices to the SMARTRF05EB. Then how to find out what are the values been displayed in Packet Sniffer.

What for Studio7 ?

Z tool is not recognizing my CC2530 ? what is the reason, any one guide me. I am totally struck with just displaying the temperature in ZED and passing it to ZC.

Any one tell how to proceed .

  • 0
    Guru 735695 points
    1. What kind of external devices do you want to connect to SmarRF05EB?
    2. Packet sniffer only shows over the air Zigbee raw data and can't decode encryption of Zigbee HA profile. I would suggest you to use Ubiqua Packet Analyzer to sniff the Zigbee message.
    3. You can refer to http://www.ti.com/tool/smartrftm-studio&DCMP=hpa_rf_general&HQS=Other+OT+smartrfstudio for SmartRF Studio 7 information.
    4. Do you connect RS-232 cable to SmartRF05EB? If the connection is correct, you should check baud rate setting.
  • 0 in reply to YiKai Chen
    Genius 3220 points
    sir,
    I have installed Smart RF studio 7 , i am able to get the transceiver and receiver messages , but other contents i am not able to view.
    How to check the baud settings ?
  • 0 in reply to AMUDHA GUNASEKARAN1
    Guru 735695 points
    What contents you can't see? What do you mean how to check baud settings?