Endpoint query

Edge Goldberg

Other Parts Discussed in Thread: CC2531, Z-STACK

Hello,

I am a beginner here. After installing and working with Z-Stack_Linux_Gateway-1.0.1 on packet sniffer cc2531 and ZAP, I see the endpoints from 2 to 6 on UI. But when I burn a code with Sample Light application on router with endpoint as 8. How am I still able to connect and control ( on/off ) the router from the gateway?

over 11 years ago

0 YiKai Chen over 11 years ago

Guru 735695 points

When you send toggle command, use 8 as destination end point.

0 Edge Goldberg over 11 years ago in reply to YiKai Chen

Intellectual 955 points

It is already controlling that sample light application with endpoint 8. My question is if there is no endpoint with id 8 ( as seen from UI ) on source side how is it still controlling sample light application?

0 YiKai Chen over 11 years ago in reply to Edge Goldberg

Guru 735695 points

I suppose that is because of binding.

Zigbee & Thread

Zigbee & Thread forum

Endpoint query