cc2530 module

Thank you sir..

Dear YK Chen
I want to operate the zigbee network in the channel 16 for that I configured the module with that channel. After started the module as coordinator it shows the channel no. is 19.
is it possible to operate the zigbee network with our required channel?

Of course you can fix it to channel 16. You can enable the following two defines in f8wconfig.cfg

-DDEFAULT_CHANLIST=0x00010000 // 16 - 0x10
-DMAX_CHANNELS_24GHZ=DEFAULT_CHANLIST

Dear YK Chen
I configured the channel 16 in the module by using zigbee write command with configuration id 0x84. but it operated in channel 19.
I get channel status by using get device info command(ZB_GET_DEVICE_INFO).

Dear YK Chen
I configured the channel 16 in the module by using zigbee write command with configuration id 0x84. but it operated in channel 19.
I get channel status by using get device info command(ZB_GET_DEVICE_INFO).

Please take a look at this post. It may be helpful: http://e2e.ti.com/support/wireless_connectivity/f/158/p/345374/1208179#1208179

Thank you sir.

sir how to read the .7z file

Dear The DarkSide
Is it first install the Z-Stack-Mesh-1.0.0 to read the Znp_Script_example.7z?

Dear TheDarkSide
I looked in the post http://e2e.ti.com/support/wireless_connectivity/f/158/p/345374/1208179#1208179.
In that post the information in ascii format while open the files with notepad. how it is useful to me?

7z is a compressed file. You have to decompress it first to get ZNP scripts inside. After you get it, you have to use Z-tool to run the script.

Dear YK Chen
Sir please tell me which software is used to extract the .7z files?

Dear TER
I extracted the .7z files using rar software then it gives two files i.e znp-bringupC.zjs,znp-bringupR.zjs.
how to get the information from above files.

You can open Z-tool and go to "Tools"-> "Script Window". It will open Script Control window and you can load these two scripts and run it.