Does the POLL_RATE affect the device which is always poweron？

The Seven

Guru 11440 points

Other Parts Discussed in Thread: Z-STACK

Hi everyone ，

if the device do not set Power Saving ， does it matter How big we set the POLL RATE?

Does the POLL RATE always affect the power on device receive msg？

BR！

0 YiKai Chen over 11 years ago

Guru 735695 points

Yes, POLL_RATE always affects the power.

0 The Seven over 11 years ago in reply to YiKai Chen

Guru 11440 points

Hi yikai
if i want the device always stand by for receive the msg which come from his parents ，

do i only enable the DRFD_RCVC_ALWAYS_ON ？？？

0 YiKai Chen over 11 years ago in reply to The Seven

Guru 735695 points

Yes.

0 The Seven over 11 years ago in reply to YiKai Chen

Guru 11440 points

but when i enable this define as below ：

DRFD_RCVC_ALWAYS_ON =TRUE

the device could not sucess in EZMODE action.

when device toggle the EZMODE ， it will be EZMODE_STATE_FINISH quickly，but pData->sFinish.err was not the EZMODE_ERR_SUCCESS

0 YiKai Chen over 11 years ago in reply to The Seven

Guru 735695 points

I don't see the relevance between RFD_RCVC_ALWAYS_ON =TRUE and this problem. Do you revise anything in Z-Stack which might cause this problem?

0 The Seven over 11 years ago in reply to YiKai Chen

Guru 11440 points

but when i set RFD_RCVC_ALWAYS_ON =FALSE ， EZMODE could be success， although others files are all same。

0 YiKai Chen over 11 years ago in reply to The Seven

Guru 735695 points

Just have a test with SampleLight (ZC) and SampleSwitch(ZED wtih RFD_RCVC_ALWAYS_ON =TRUE). EZ-mode works just fine.

Zigbee & Thread forum