OTA with CC2538 SmartRF06 board

Arash Azarmi

Other Parts Discussed in Thread: CC2538, CC2530

Hi TI,

Can I use the OTA module and console with SmartRF06 CC2538 eval board?

If not, Please point where I can find the code/image to restore my CC2530 SmartRF05 eval board to original state. So then I can follow the doc on adding OTA to the client,

Thanks

over 11 years ago

0 TheDarkSide over 11 years ago

TI__Genius 16570 points

You can restore the firmware on SRF05EB by following section 11 of this document www.ti.com/.../swru210a.pdf
The default firmware with latest SmartRF Flash programmer is at

[YOUR DEFAULT DIRECTORY INSTALL]\SmartRF Tools\Firmware\SmartRF05EB

Thanks,
TheDarkSide

0 Arash Azarmi over 11 years ago in reply to TheDarkSide

Intellectual 885 points

Smart RF Tools does not show the options in doc. There is no tab for smartRF05DK. Please see below

Also the default folder has only these 2 files:

cebal_fw_srf05eb.hex
usb_bootloader_srf05eb.hex

0 YiKai Chen over 11 years ago in reply to Arash Azarmi

Guru 735695 points

You suppose to choose 2.4GHz tab in SmartRF Studio 7.

0 Arash Azarmi over 11 years ago in reply to YiKai Chen

Intellectual 885 points

It doesn't make a difference it doesn't list the smartRF05 boards only lists the MCUs.
The description in doc is very different. Is it supposed to work with older version of Smart RF Studio?

0 Arash Azarmi over 11 years ago in reply to Arash Azarmi

Intellectual 885 points

Would you please help me with this.

As you see above when I connect my smartRF05 board, smart Rf Tools recognize it as CC debugger.

For programming it to right flash as recommended in document,

I don't see following:

<installation_dir>\extras\srf05eb\srf05eb_fwid0500.hex

in any of my installed Smart RF tools directory. Below is my directory structure.

The only hex codes for smartrf05 are

cebal_fw_srf05eb.hex

usb_bootloader_srf05eb.hex

Zigbee & Thread

Zigbee & Thread forum

OTA with CC2538 SmartRF06 board