migrating from CC2538 to CC2650

Salento Quindio

Other Parts Discussed in Thread: CC2650, BLE-STACK, CC2640

I have a program running over a CC2538EM, We recently acquired a CC2650EM and was wondering what I need to change to make the program run in the new chip... my experience with MCU programming is very basic.

thank you in advance for any guide you can give me.

over 10 years ago

0 JXS over 10 years ago

TI__Guru** 105180 points

Hi Salento,

Are you looking to run ZigBee on the CC2650 or BLE?

Best wishes

0 Salento Quindio over 10 years ago in reply to JXS

Intellectual 300 points

eventually BLE, the program is running the 2538 right now does not use any communications it just get data from a sensor via SPI

0 JXS over 10 years ago in reply to Salento Quindio

TI__Guru** 105180 points

For BLE, it's best to start with BLE v2.0 SDK, which is available here: www.ti.com/ble-stack
There is a SW Developer's Guide (SWRU393) which is included in the SDK. This document has a lot of useful info for getting up & running on the CC2640 (CC2650).
You can also see additional examples on the BLE Wiki: www.ti.com/ble-wiki

As always, please use the Bluetooth low energy E2E forum: e2e.ti.com/.../538

Best wishes

0 Salento Quindio over 10 years ago in reply to JXS

Intellectual 300 points

thank you I will check, in the meantime is there a way to translate my program to the new chip or I have to write the program all over again?

Zigbee & Thread

Zigbee & Thread forum

migrating from CC2538 to CC2650