How often does the Enddevice send out a joinrequest Msg while it was orphan

The Seven

Guru 11440 points

Hi everyone

does anybody knows how does the enddevice send out a joinrequest Msg while it was orphan？

could we change this frequency about resending join request Msg？

how to change？

over 10 years ago

0 YiKai Chen over 10 years ago

Guru 735685 points

You can try to change REJOIN_POLL_RATE in f8wconfig.cfg.

0 The Seven over 10 years ago in reply to YiKai Chen

Guru 11440 points

could i change as long as i want ?
or is there any limit?

0 YiKai Chen over 10 years ago in reply to The Seven

Guru 735685 points

It is an uint16 so the max value is 65535. However, if you set it too large, the device will rejoin back very slow. This is trade-off between power consumption and Zigbee network resume.

0 The Seven over 10 years ago in reply to YiKai Chen

Guru 11440 points

Hi yikai
does this could change in APP.c By using Fuction anytime ,just like changing the POLLRATE

0 YiKai Chen over 10 years ago in reply to The Seven

Guru 735685 points

No, there is no API for changing REJOIN_POLL_RATE.

Zigbee & Thread

Zigbee & Thread forum

How often does the Enddevice send out a joinrequest Msg while it was orphan