How to get binding information through Z-Stack Gateway API?

Yes. i have one light and one switch that they can bind by hardware key.
I want my application detect that these 2 devices are binded.

You can try to register Mgmt_Bind_rsp and send ZDP_MgmtBindReq to get binding table from device.

Thank you for your solution. Can you explain more precisely?
Where i must register Mgmt_bind_rsp and send ZDP_MgmtBindReq?
On my devices or on my application?

I register Mgmt_bind_rsp on my switch device.
ZDO_RegisterForZDOMsg(zclSampleSw_TaskID, Mgmt_Bind_rsp);
Then i use Z-Tool for send ZDP_MgmtBindReq but i got the error.

<TX>10:33:39.39 COM4 ZDO_MGMT_BIND_REQ (0x2533)
DstAddr: 0x3A8F
StartIndex: 0x00

<RX>10:33:39.41 COM4 SYS_RPC_ERROR (0x6000)
Status: INVALID_COMMAND (0x2)
ErrCmd0: 0x25
ErrCmd1: 0x33

Please guide me to use this solution.

Try to enable MT_ZDO_MGMT in your ZNP project.

Thank you.
But i don't know how to use this solution in my application?
My application is based on java language.

No one can help me?

No Answer?!!!!

Hi No Body,

While the gateway API supports creation of bindings between any pair of devices in the network, unfortunately it does not support reading the existing binding information.

The procedure suggested by YK may be used to enable reading of the binding table by the SoC, but this will not directly be supported by the Linux gateway middleware and its existing API.

TI will consider this as a feature request, and may include this in a future release of the gateway.

Best regards,
OD

It's definitely a good news that TI consider this as a new feature in future release of GW. I am looking forward to testing it.

Can i use the ZDP_MgmtBindReq API from Z-Stack API in my application to retrieve the binding information?

Where does your application run? On Linux GW or Zigbee coordinator?

My application runs on linux GW.

Thank you.
Therefore this is a significant defects, because when devices bind together by hardware interface there is no way application detect it.

I think it is not mandatory to know binding details in application. I know it is better to have and I think that's why OD said TI would consider to implement in Linux GW reference design.