CC2530: "XdataStack" (currently XData:0x0000) is outside the stack range (XData:0x0001 to XData:0x0301)

H-Son

Prodigy 60 points

Other Parts Discussed in Thread: CC2530, Z-STACK

Hi All,

I download my code to chip CC2530 have a error.

I used Z-Stack 1.2.1.

I have downloaded this code to CC2530ZDK, it run ok! but when download to chip CC2530 (sample from TI), it error.

I searched that error but don't see resolve. Can anyone help me?

Sorry for my english so bad!

over 10 years ago

0 YiKai Chen over 10 years ago

Guru 735625 points

Check if your CC2530 only has 128K flash.

0 H-Son over 10 years ago in reply to YiKai Chen

Prodigy 60 points

my CC2530 is CC2530F256. it is written on chip.

0 YiKai Chen over 10 years ago in reply to H-Son

Guru 735625 points

Try to use flash programmer to download hex and see if your Cc2530 works.

0 H-Son over 10 years ago in reply to YiKai Chen

Prodigy 60 points

I tried to use flash progarmmer but it error "Could not open specified hex file".

0 H-Son over 10 years ago in reply to H-Son

Prodigy 60 points

Thanks Yikai Chen so much,
I could download to CC2530 by flash programmer. But, i would to kown why IAR cannot download and debug it? where is problem? linker? config stack? or other?

0 YiKai Chen over 10 years ago in reply to H-Son

Guru 735625 points

Make sure the following two lines are commented out in f8w2530.xcl

//-M(CODE)[(_CODEBANK_START+_FIRST_BANK_ADDR)-(_CODEBANK_END+_FIRST_BANK_ADDR)]*\
//_NR_OF_BANKS+_FIRST_BANK_ADDR=0x8000

Zigbee & Thread

Zigbee & Thread forum

CC2530: "XdataStack" (currently XData:0x0000) is outside the stack range (XData:0x0001 to XData:0x0301)