SmartRF flash programmer CC2530

Ali Reeza

Expert 1250 points

Other Parts Discussed in Thread: CC2530, CC2531, CC2538

I am trying to program CC2530 with SmartRF flash programmer.

I have connected CC2530 to serial port through P0.2 (Rx) P0.3 (Tx) which I am not sure to be right.

Flash program show connected device ass unknown and there is no CC2530 option in select target device menu.

Advice me please.

0 YiKai Chen over 10 years ago

Guru 735695 points

You have to use CC debugger to program CC2530.

0 Ali Reeza over 10 years ago in reply to YiKai Chen

Expert 1250 points

Thanks.
So it means that there is no way to program CC2530 flash via serial port with tools like serialboottool!?

0 YiKai Chen over 10 years ago in reply to Ali Reeza

Guru 735695 points

No, you have to use CC debugger.

0 Ali Reeza over 10 years ago in reply to YiKai Chen

Expert 1250 points

Thank you. By the way using CC debugger I still had the same problem which was solved by using flash programmer instead of flash programmer 2.

0 YiKai Chen over 10 years ago in reply to Ali Reeza

Guru 735695 points

Yes, Flash programmer is for CC2530/CC2531. Flash Programmer 2 is for CC2538 and CC26xx.

Zigbee & Thread forum