cc2530 joins the network without permit join.

Dhanraj

Guru 14820 points

Other Parts Discussed in Thread: CC2530, Z-STACK, CC2531

Hello,

I am working with z-stack home 1.2.1 on cc2530 which is configured as router.

and cc2531 with BBB and linux HA Gatway act coordinator.

ideally the router should join the network after permit join,but my router is joining the network without permit join.

How to resolve the issue?

thanks a lot in advance.

Regards

Dhanraj

over 10 years ago

0 YiKai Chen over 10 years ago

Guru 735705 points

Try to erase the flash of your ZR and download FW to test again.

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

I always select the option "erase,program and verify" while programming .

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

Try to use Ubiqua Packet Analyzer to check why this happens.

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

what I am suppose to observe in ubiqua protocol analyzer?

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

You can use Ubiqua Packet Analyzer to see how it joins coordinator.

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

I have tried but unable to get ubiqua protocol analyser?
SO I request you to suggest me any other way to solve the issue.

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

What do you mean unable to get Ubiqua Packet Analyzer? You can get it from www.ubilogix.com/.../ubiqua.

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

i have already used my trial period.

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

Try to use ZBOSS sniffer.

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

I have attached the sniffer log file.

rejoin without permit join request.rar

please have a look on it.

the device with IEEE address (00:12:4B:00:01:C3:18:FC) has joined the network without permit join.

I have removed the device from the network and then after some time the device is automatically joined the network.

this is not desired according to my requirement.

Regards

Dhanraj

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

Can you specify which packet you see this issue in your sniffer log?

0 Dhanraj over 10 years ago in reply to YiKai Chen

Guru 14820 points

please refer to packet no.728 and onwards.

the device is joining the network without permit join from co-ordinator.

0 YiKai Chen over 10 years ago in reply to Dhanraj

Guru 735705 points

The problem is on your ZR (0xf01e) which is enable permit join. You can see it in packet number 1055.

Zigbee & Thread

Zigbee & Thread forum

cc2530 joins the network without permit join.