microsecond timer in sampleSwitch

Stephanie Werner

Expert 1665 points

Other Parts Discussed in Thread: Z-STACK

Hello,

is there a document, that describes how to configure a timer in microsecond steps?

Util_constructClock() only allows for configuration in 1ms steps

over 9 years ago

0 YiKai Chen over 9 years ago

Guru 735685 points

Do you intend to have a delay in microseconds or you want to create an event in microseconds interval?

0 Stephanie Werner over 9 years ago in reply to YiKai Chen

Expert 1665 points

I want an event in microseconds interval. I need a (timer) callback every 240 µs

0 YiKai Chen over 9 years ago in reply to Stephanie Werner

Guru 735685 points

You might need to use GPTimer driver to do it by yourself. You can refer to e2e.ti.com/.../474000

0 Stephanie Werner over 9 years ago in reply to YiKai Chen

Expert 1665 points

I was afraid that this might be the answer.
Okay, then i'll have to try to get a newer tirtos version running in order to use this. Upgrading to tirtos 2.20 seems not to work with the current z-stack.
thank you

0 YiKai Chen over 9 years ago in reply to Stephanie Werner

Guru 735685 points

You are welcome and good luck to you.

Zigbee & Thread

Zigbee & Thread forum

microsecond timer in sampleSwitch