Adding OTA Client functionality

Kumar M

Intellectual 945 points

Other Parts Discussed in Thread: Z-STACK, CC2530EM

I am using SampleLight project in z-stack home automation as a reference project.

I am trying out this using CC2530EM Evaluation Modules and SmartRF05EB Evaluation Boards.

I want to add OTA Client functionality to the SampleLight Project.

I have followed the procedure in OTA manual (Section 4 of Z-Stack OTA Upgrade User's Guide - SWRA353 Version 1.6).

I can able to build, but after flashing the files, the board is not entering into EZMode. And not all pairing with ZigBee Coordinator.

Can anyone help me out on this?

over 9 years ago

0 YiKai Chen over 9 years ago

Guru 735695 points

Does your device send beacon requests to join Zigbee network? What do you mean the board doesn't enter EZ mode?

0 Kumar M over 9 years ago in reply to YiKai Chen

Intellectual 945 points

The board , I mean to say the test setup (CC2530EM Evaluation Module and SmartRF05EB Evaluation Board).

When I press SW2, it should enter EZMode but it is not happening. And it is not getting associated with ZigBee Coordinator. Don't know whether it is sending the parring request to ZC.

0 YiKai Chen over 9 years ago in reply to Kumar M

Guru 735695 points

I suggest you to use Ubiqua Packet Analyzer to check it.

0 Kumar M over 9 years ago in reply to YiKai Chen

Intellectual 945 points

I have solved this issue. The problem is that I have missed some things from section 3.2 of the OTA Upgrade user manual.

0 YiKai Chen over 9 years ago in reply to Kumar M

Guru 735695 points

It is good to know it works now.

Zigbee & Thread

Zigbee & Thread forum

Adding OTA Client functionality