CC2538-SW: Additional endpoint

Giovanni Cuccoli

Part Number: CC2538-SW

I developped an application with endpoint 232 and Zcl cluster 0x0011, now the customer requested us to insert un another Endpoint and another cluster for Debug msg.

To satisfy this request I think that I have to add another task in my project, Is it the right solutions ?

Can anyone give me some suggestions ?

Thanks

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

Yes, your understanding is correct.

0 Giovanni Cuccoli over 8 years ago in reply to YiKai Chen

Prodigy 30 points

Ok,

Can you tell me where I can find some examples ?

Thanks

0 YiKai Chen over 8 years ago in reply to Giovanni Cuccoli

Guru 735695 points

You can refer to SampleSwitch OTA example which runs OTA on separate endpoint.

0 Giovanni Cuccoli over 8 years ago in reply to YiKai Chen

Prodigy 30 points

Thanks

0 JasonB over 8 years ago in reply to Giovanni Cuccoli

TI__Expert 8950 points

Hi Giovanni,

As you mentioned, you will need to add another task to your project. You can read more about the implementation of a multi-endpoint device here:

processors.wiki.ti.com/.../Multi-endpoint_device_implementation

As YK said, the OTAClient configuration of SampleSwitch shows an example of this. The additional task created for the OTA endpoint is OTA_task.

Zigbee & Thread

Zigbee & Thread forum

CC2538-SW: Additional endpoint