CCS/CC2530: Low address is changed when use zcl_SendRead to send data.

Alvin Chen

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK

Tool/software: Code Composer Studio

My ZigBee network has only one coordinator and one Enddvice.The coordinator to send data to the Enddvice by zcl_SendRead. After 3 hours ，Low address is changed and Enddvice can't achieve data.

I find the destination address is 0xFFFF, this should be 0xAADA.

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

Which Z-Stack version and example do you test? Do you enable NV_RESTORE when you test this?

0 Alvin Chen over 8 years ago in reply to YiKai Chen

TI__Expert 3925 points

I will try to enable NV_RESTORE.thank you.

0 YiKai Chen over 8 years ago in reply to Alvin Chen

Guru 735695 points

You are welcome.

Zigbee & Thread

Zigbee & Thread forum

CCS/CC2530: Low address is changed when use zcl_SendRead to send data.