CC2530: How to Setup ZDP Match Descriptor Req

Can you elaborate what you mean you cannot do it?

Hi Mr Yikai,
I want to send ZDP match descritor request during the join procedure from my Device ( ZR based on the project Simplesligth) to Gateway (TI ZC).
I tried to implement on ZDO_Stautus_change, after DeviceAnnuce procedure.

Would you can advise, please, how to call the function reponsable for to send zDP Match descriptor request?

BR
Alex

Can you post your code and use it to elaborate your question?

Hi Mr Yikai, would you see my post bellow.

if ( events & SYS_EVENT_MSG )
{
while ( (MSGpkt = (afIncomingMSGPacket_t *)osal_msg_receive( zclSampleLight_TaskID )) )
{
switch ( MSGpkt->hdr.event )
{
case ZCL_INCOMING_MSG:
// Incoming ZCL Foundation command/response messages
zclSampleLight_ProcessIncomingMsg( (zclIncomingMsg_t *)MSGpkt );
break;
case ZDO_STATE_CHANGE: // written by ASA
{
ZDApp_AnnounceNewAddress();
ZDP_MatchDescReq(); // it´s not working
}
break;

I trying to call ZDP_MatchDesReq after the Device_Annce function, but i have problem to compile the function. I was declare in two form as you can see bellow, but in boths the IAR compiler does not let continue.

BR
Alex

What parameters do you use when you call ZDP_MatchDescReq() in ZDO_STATUS_CHANGE?

I used this to call:

ZDP_MatchDescReq( zAddrType_t *dstAddr, uint16 nwkAddr,
uint16 ProfileID,
byte NumInClusters, cId_t *InClusterList,
byte NumOutClusters, cId_t *OutClusterList,
byte SecurityEnable );

But IAR complined all those parameter, as not declared.
BR
Alex

Hi Mr Yikai, thanks a lot I´ll working on it.

BR
Alex