CC2530: Device responds late

Jack Loop

Part Number: CC2530

Hi,

I've noticed a problem where whenever I send a signal from the coordinator to my end device, then end device may take up to 2 polls (poll rate = 1sec) before it actually receives the signal. It can even sometimes take up to 3-5 polls. Why doesn't the end device consistently take action after 1 poll? How can I improve the end device to respond at the right time and not late?

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

Can you attach sniffer log and point where you see the issue in your log?

0 Jack Loop over 8 years ago in reply to YiKai Chen

Guru 17870 points

I tested this with an oscilloscope and I see this result. I don't have a sniffer log.

0 YiKai Chen over 8 years ago in reply to Jack Loop

Guru 735695 points

I don't think it's accurate to prove your descriptions using scope. I suggest you to use sniffer to check it.

Zigbee & Thread

Zigbee & Thread forum

CC2530: Device responds late