CC2530EMK: CC2530EMK

NISHA MISHRA

Prodigy 190 points

Part Number: CC2530EMK
Other Parts Discussed in Thread: CC2530, , Z-STACK

Hi,

Can this modules be directly interfaced with any TI micro controller ?

What is the Data throughput?

Can data read from micro-controller be sent to this module and be received by another module?

Regards,

Nisha

over 6 years ago

0 YiKai Chen over 6 years ago

Guru 735455 points

CC2530 supports UART and SPI so you can use these two interfaces for communicating with other MCU.

0 NISHA MISHRA over 6 years ago in reply to YiKai Chen

Prodigy 190 points

Do you need to program both MCU and CC2530 EMK separately ? or it can be programmed through an Host MCU?

0 YiKai Chen over 6 years ago in reply to NISHA MISHRA

Guru 735455 points

I am not sure what MCU you mean but you need to program CC2530EMK separately.

0 NISHA MISHRA over 6 years ago in reply to YiKai Chen

Prodigy 190 points

When the host controller is interfaced using SPI/UART and data to be sent from Host conroller to CC2530EMK which will further be received by next kit; how the programming will be done?

0 YiKai Chen over 6 years ago in reply to NISHA MISHRA

Guru 735455 points

Do you run Z-Stack ZNP on your CC2530EMK?

Zigbee & Thread

Zigbee & Thread forum

CC2530EMK: CC2530EMK