How to get Z_Stack_Linux_Gateway binaries for Raspberry Pi- 3

The prebuilt binary for ARM should be able to run on Raspberry Pi directly without problem.

Dear YK Chen,

Is there any different steps from beaglebone whcih I need to execute in raspbarry pi in order to run z-stack linux gateway in raspberry pi? Or it's the same steps/command what I executed in beaglebone?

Best regards,
Mahbu

It's the same step.

I have transfared the binaries.tar file to the Raspberry pi. And I am getting following error while executing command "sudo cp protobuf/libprotobuf-c.so.0 /usr/lib/"

error:
cp cannot state protobuf/libprotobuf-c.so.0 "no such file or directory"

Any suggetion please!

I'm getting error (No such file or directory) while executing the command sudo cp protobuf/libprotobuf-c.so.0 /usr/lib/

Try to refer to steps in sunmaysky.blogspot.com/.../how-to-do-porting-of-ti-z-stack-linux.html

Thank you.
I have successfully created linux gw in raspberry pi but the problem is that sensor tag cannot connect to the linux_gateway even I made permit join. But the same sensorTAG is working fine when I try to connect beaglebone linux gw.

could you please suggest me how can resolve the problem and connect the sensortag to the raspberry pi linux gw!

Try to erase Flash of your SensorTag and download Zigbee hex to it again to test.

Thank you for your suggetion.

Could you please tell me how can I get the Zigbee hex! If you have then could you give me, please !

If you don't have it, how do you make your SensorTag join Z-Stack Linux Home GW running on BBB?

Sorry! I thought you mean different hex file. Thank you anyway!

Thank you so much YK Chen,

The sensor Tag is now connected with Linux GW in Raspberry pi.

Cheers!