CC2538: Zigbee PRO compatibility with Zigbee

As I know, Z-Stack always use ZigbeePro. What do you mean Zigbee here?

Hi Chen,
Z-Stack use Zigbee Pro if I define "ZIGBEEPRO" else it use only Zigbee. I found that Zigbee Pro is update of Zigbee. In the application we can use any one. So, I want confirmation can both the type of devices were compatible in network connection and communication.
Zigbee Pro has all the functionalities of Zigbee with additional features, I found some difference here:
www.rfwireless-world.com/.../zigbee-vs-zigbee-PRO.html

thank you

Hi Chen,
while reviewing the projects of Z-Stack I found that Initial only Zigbee is enabled, If we want ZigbeePro we have define "ZIGBEEPRO".
ZigbeePro has all the functionalities of Zigbee with additional features.
So I want know does both Zigbee and ZigbeePro devices can connect to the same network and Communicate.
In the Stack no need to change anything, it work for both ZIgbee and Zigbee Pro.

I found some differences here:
www.rfwireless-world.com/.../zigbee-vs-zigbee-PRO.html

Thank you.

Hi Chen,
If I want to use ZigbeePro, I has to define "ZIGBEE PRO" in the project. Else it uses only Zigbee. So my doubt is can both type connect to same network and communicate.

Which Z-Stack version do you use?

There are some spec change between Zigbee and ZigbeePro. It will have problem if you mix them in the same system.

Hi Chen,
I am using "Z-Stack 3.0",
My main intention is like this I will enable all my devises with Zigbee Pro, as well I want to give an access to any other third party devices which can be ZED or ZR with Zigbee or Zigbee Pro.
Is this possible?

Thank you.

If 3rd party devices run HA profile or Zigbee 3.0, they must use ZigbeePro

hi chen,
If the third party device is run HAprofile or Z-Stack3.0 does it directly connect to my network by keep in steering.
If yes?, How can I know the ON or OFF or other commands to access the third party devices

Thank you.

If 3rd party device runs the same profile with your Zigbee network, it should be no problem to connect to your network. ON/OFF or other commands are well defined in ZCL spec and device should follow the spec if it’s claimed to HA profile or Zigbee 3.0.

Thank you for quick response,
I will come back if I found any issue.