CC2538DK: RIOT OS

Can you do a screenshot to show me where you see the message?

Thankyou sir , I ported RIOT onto cc2538dk.

Hello sir,

I want to implement Z-Stack in RIOT OS.

* I want one zigbee module with zigbee stack.
* That zigbee stack should work on RIOT OS.
* I Want to build zigbee stack directly in OS NOT with IDE.
* My Application is simple, want to handle end device by using zigbee protocol,but that stack should be build-ed with RIOT OS.

when iam compiling Zstack onto cc2538 i am getting errors , i have the licence of IAR version 7.30.please resolve the issue.

Thankyou sir

Hello sir,

I have ported the Z-Stack Mesh 1.0.0 onto cc2538

one as Coordinator, one as Router, three as Enddevices, But when i am pressing the SW2 and SW4 then only they are pairing and the message is received by the coorinator.

my problem is that when the Coordinator is powered as it starts the network and the enddevice needs to join&pairing directly into the coordinators network and send the message without pressing the keys.

will you please tell me where&how to change the code.

hello sir,

I have uploaded adc temperature sensor(which is in foundation firmware example) code onto cc2538 board, and i am getting output in uart (COM10) like this where as i got usb(COM7) like this. Is there any problem in UART communication. please tell me

You mean you have connect two smartRF06 to your PC, one is COM10 and another is COM18. If you run the same example on both smartRF06, you will see correct output on COM18 but incorrect on COM10???

Both boards are not giving the correct output

You will set port by specifying which tty interface is being created at /dev/ folder. Usually it is /dev/ttyUSB1.  

using ZNP example is it possible