CC2650EM-5XD-RD: PER TEST

Dhanraj

Part Number: CC2650EM-5XD-RD
Other Parts Discussed in Thread: CC2650EMK, CC2650

Hello,

I am using a cc2650emk with smart RF 05 board and programmed with PER TEST firmware.

Another cc2650emk i have connected to smartrf studio 7.now i want to transmit packet from smartRF studio and receive on smartR board.

i tried to do it but i am not receiving any data on smartRF board.

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

If you run PER test FW on both CC2650EMK, does it work?

0 Dhanraj over 8 years ago in reply to YiKai Chen

Guru 14820 points

YES

0 YiKai Chen over 8 years ago in reply to Dhanraj

Guru 735695 points

Why do you need to use one running PER FW and another is runn by SmartRF Studio?

0 Dhanraj over 8 years ago in reply to YiKai Chen

Guru 14820 points

because my second device is cc2650_5x5 custom device,which i am connecting to smartRF board through 10pin jtag cable instead of mounting on smartrf board like cc2650emk.

0 YiKai Chen over 8 years ago in reply to Dhanraj

Guru 735695 points

Why don’t you use SmartRF Studio on both devices?

0 Dhanraj over 8 years ago in reply to YiKai Chen

Guru 14820 points

because with smart rf studio whatever results m getting is not consistent,
sometimes it gives me 50% per and sometime it gives me 10% per.

0 YiKai Chen over 8 years ago in reply to Dhanraj

Guru 735695 points

If you see this low PER, it means there’s something wrong on your HW.

Zigbee & Thread

Zigbee & Thread forum

CC2650EM-5XD-RD: PER TEST