CC2531: ZNP Neighbor table

Arunkumar V R

Expert 1040 points

Part Number: CC2531
Other Parts Discussed in Thread: Z-STACK

How can i obtain the network table of a ZNP coordinator????

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

There’s no API to get neighbor table for ZNP.

0 Arunkumar V R over 8 years ago in reply to YiKai Chen

Expert 1040 points

can i use ZDO_mgmtLqiReq??

0 YiKai Chen over 8 years ago in reply to Arunkumar V R

Guru 735695 points

Oh! Sorry, ZDO_mgmtLqiReq can do this.

0 Arunkumar V R over 8 years ago in reply to YiKai Chen

Expert 1040 points

do you know how the response is generated???

0 JasonB over 8 years ago in reply to Arunkumar V R

TI__Expert 8950 points

Check "3.12.2.16 ZDO_MGMT_LQI_RSP" in Z-Stack Monitor and Test API, in the Z-Stack 3.0.1 docs folder

0 YiKai Chen over 8 years ago in reply to Arunkumar V R

Guru 735695 points

When you send command to device, it should collect the LQI information in the table and do LQI response.

0 Arunkumar V R over 8 years ago in reply to JasonB

Expert 1040 points

I'm using Z-Stack 1.2

0 Arunkumar V R over 8 years ago in reply to YiKai Chen

Expert 1040 points

I'm asking about the function that process the request in the ZNP coordinator!!

0 YiKai Chen over 8 years ago in reply to Arunkumar V R

Guru 735695 points

You can refer to ZDO_ProcessMgmtLqiReq().

0 Arunkumar V R over 8 years ago in reply to YiKai Chen

Expert 1040 points

It is not used in a ZNP Coordinator, there is no referance or call to this function in the given Gateway Source code

0 YiKai Chen over 8 years ago in reply to Arunkumar V R

Guru 735695 points

I couldn’t understand your question. We usually send LQI requests from coordinator to all devices to collect LQI response. What do you expect to know on ZNP coordinator?

Zigbee & Thread

Zigbee & Thread forum

CC2531: ZNP Neighbor table