RTOS: LED not working on P1.0 Pin

Kamlesh Patel49

Other Parts Discussed in Thread: CC2592, CC2530, Z-STACK

Tool/software: TI-RTOS

Dear All

i have used Zstack home for my board CC2530+CC2592. i have attached my schematic.

in software when i #defined HAL_PA_LNA_CC2592 then my LED is not working on P1.0.but when undefined it my LED is working properly.

please give me solution.thanks in advance.

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

When you define HAL_PA_LNA_CC2592, Z-Stack would enable P1.0 to control LNA_EN. Since you use P1.0 as LED, you have to revise code according to your schematic.

0 Ryan Brown1 over 8 years ago

TI__Guru**** 222577 points

To add on to YiKai's answer and dependent on the Z-Stack version you are using, the code you need to change can be found in HAL/Target/CC2530EF/Config/hal_board_cfg.h and MAC/LowLevel/System/mac_radio_defs.c

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

RTOS: LED not working on P1.0 Pin