Compiler/CC2530: how identify mesh or tree net work and change it in z-stack 3.0.1 ?

quang nguyen76

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK

Tool/software: TI C/C++ Compiler

I'm using z-stack 3.0.1 and cc2530. I'm use sample Generic_app to create new zigbee network. But i don't known it is tree or mesh topology and how to change it.

Thanks.

Quang

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735705 points

Z-Stack supports mesh network by default. If you add one more router into Zigbee network, it would do mesh routing automatically.

0 quang nguyen76 over 8 years ago in reply to YiKai Chen

Expert 1370 points

and how i can change it to tree topology. What layer in stack rules it ?

0 YiKai Chen over 8 years ago in reply to quang nguyen76

Guru 735705 points

You cannot set it to tree topology.

0 quang nguyen76 over 8 years ago in reply to YiKai Chen

Expert 1370 points

cause of it is version of z-stack or characteristic of zigbee network ? I see in some document that say zigbee have three topology : star, tree, mesh.

0 YiKai Chen over 8 years ago in reply to quang nguyen76

Guru 735705 points

I remember old Zigbee spec (before 2006) support tree topology but it only supports mesh after that until now.

0 quang nguyen76 over 8 years ago in reply to YiKai Chen

Expert 1370 points

ok. thanks you very much.

Zigbee & Thread

Zigbee & Thread forum

Compiler/CC2530: how identify mesh or tree net work and change it in z-stack 3.0.1 ?