CC1352R: protocol supported by cc1352 for mesh network

Dhanraj

Guru 14820 points

Part Number: CC1352R
Other Parts Discussed in Thread: Z-STACK

Hello,

1) protocol supported by 2.4 Ghz radio and software stack available.

2) Network Topology supported by 2.4 Ghz radio for available stack

3) protocol supported by sub 1 Ghz radio and software stack available

4) Network Topology supported by sub 1 Ghz radio and stack

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

All are Yes. You can refer to dev.ti.com/.../

0 Dhanraj over 8 years ago in reply to YiKai Chen

Guru 14820 points

1) does sub 1 Ghz have any support for mesh network if yes then which protocol and stack other then 6Lowpan??
2) Does BLE 5 stack support mesh network?
3) Is there any solution available for mesh network , where Network joinng procedure is not required like CSRMESH(Qualcomm)

0 YiKai Chen over 8 years ago in reply to Dhanraj

Guru 735695 points

1. No
2. No.
3. Z-Stack for CC1352R supports mesh.

0 Dhanraj over 8 years ago in reply to YiKai Chen

Guru 14820 points

" Z-Stack for CC1352R supports mesh."
But that require network joining procedure

0 YiKai Chen over 8 years ago in reply to Dhanraj

Guru 735695 points

As I know, every different type of mesh network require joining/commission procedure.

0 Ryan Brown1 over 8 years ago in reply to Dhanraj

TI__Guru**** 222447 points

Please stay tuned for Z-Stack support of the CC1352R scheduled to release during the middle of 2018.

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

CC1352R: protocol supported by cc1352 for mesh network