Compiler/CC2530: How to throw event at UART?

user5282543

Intellectual 550 points

Part Number: CC2530
Other Parts Discussed in Thread: TIMAC,

Tool/software: TI C/C++ Compiler

Hi,

I use TIMAC CC2530 example application(Normal-FFD).

I want to handle UART event, and get UART data.

Please tell me, How to do that?

thanks.

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735705 points

Try to refer to sunmaysky.blogspot.tw/.../how-to-use-two-uart-ports-in-cc2530-z.html

0 user5282543 over 8 years ago in reply to YiKai Chen

Intellectual 550 points

Thanks for replay.

I want to connect Arduino and CC2530.
Is there any problem with the wiring shown below?

Arduino UNO - CC2530
3.3V - VDD
GND - GND
TX - RX
RX - TX

0 YiKai Chen over 8 years ago in reply to user5282543

Guru 735705 points

It looks no problem.

0 user5282543 over 8 years ago in reply to YiKai Chen

Intellectual 550 points

thanks!

0 Ryan Brown1 over 8 years ago in reply to user5282543

TI__Guru**** 223697 points

The Arduino Uno operates I/Os at 5V and the CC2530 maximum recommended I/O voltage is 3.6V. You will therefore need some level translation hardware to compensate.

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

Compiler/CC2530: How to throw event at UART?