CC2530: IEEE Address

Ambar Jain

Intellectual 620 points

Part Number: CC2530

Hi,

If IEEE address of 3 coordinator is same then what happens ?

if all these three are active in near area.

This is all for ZigBee Home stack.

over 7 years ago

0 YiKai Chen over 7 years ago

Guru 735695 points

Each Zigbee device should have a unique IEEE address. it shouldn't happen that IEEE address of 3 coordinator are same.

0 Ambar Jain over 7 years ago in reply to YiKai Chen

Intellectual 620 points

Ok. Thanks

One more question to ask ( for confirmation if I am not wrong )

commands for permit join;

FE 26 08 00 00 FF ( for permit join )

FE 26 08 00 00 00 ( for forbide joinning )

is it correct ?

0 YiKai Chen over 7 years ago in reply to Ambar Jain

Guru 735695 points

Basic format is correct but you need to add length in the beginning of MT command and checksum to the end of your MT command.

0 Ambar Jain over 7 years ago in reply to YiKai Chen

Intellectual 620 points

yes ....

Thanks

0 Ambar Jain over 7 years ago in reply to Ambar Jain

Intellectual 620 points

Is there any chance that i missed to forbid join the coordinator with above command ?

0 Ambar Jain over 7 years ago in reply to YiKai Chen

Intellectual 620 points

Can we write IEEE using MT commands ?

0 YiKai Chen over 7 years ago in reply to Ambar Jain

Guru 735695 points

The primary IEEE address is fixed when production and you cannot change it.

Zigbee & Thread

Zigbee & Thread forum

CC2530: IEEE Address