CC2531: configure ZNP Z-stack as End Device

Babu B

Intellectual 345 points

Part Number: CC2531
Other Parts Discussed in Thread: Z-STACK

By default ZNP Z-Stack configure as a coordinator (Flag: ZG_BUILD_RTR_TYPE).

Is it possible to configure ZNP Z-stack as a end device ?

Stack version : Mesh

Thanks,

Ramesh

over 7 years ago

0 YiKai Chen over 7 years ago

Guru 735685 points

Yes, you can configure ZNP to act as end device.

0 Babu B over 7 years ago in reply to YiKai Chen

Intellectual 345 points

Ok thanks.

I have set the device type as end device.
Then sent the beacon request after initialization &
got response from coordinator becon: Nwkopen.
in-turn end device has to send the association request but in my case request is not sending.
What might be the issue ?

Thanks,
Babu

0 Babu B over 7 years ago in reply to Babu B

Intellectual 345 points

Update:
Association permit: 1 (in Becaon: nwk open signal) verified in sniffer logs.

0 YiKai Chen over 7 years ago in reply to Babu B

Guru 735685 points

Has your device join any Zigbee network before you let it start beacon? Maybe try to factory reset ZNP to test again.

0 Babu B over 7 years ago in reply to YiKai Chen

Intellectual 345 points

Tried again after ZNP reset, Its works fine.

Thank you.

0 YiKai Chen over 7 years ago in reply to Babu B

Guru 735685 points

So, this proves my guess.

Zigbee & Thread

Zigbee & Thread forum

CC2531: configure ZNP Z-stack as End Device