CC2530: Interrupt draws 0.15mA

Jack,

This cannot be modified, the RESET circuit configuration is fixed from the factory there are software changes possible to modify the behavior of that node. I am also really struggling to see why this can be important for you, could you explain why this is important?

Regards,
/TA

I am talking about a general purpose input pin, not the RST.

I need minimize the current draw to conserve battery power - the SW will be constantly pressed for a long time.

Did YK suggestion help?

Regards,
/TA

TA12012 For R1, I use about 1M, so if I swapped SW and R1 positions, the interrupt wouldn't receive enough current - therefore the interrupt wouldn't work anymore. The max resistor I can place is ~20k - but this would draw too much current. So this solution wouldn't work.

Jack,

I do not think we are able to provide any improvements on this topic, as I wrote the RESET circuit is not programmable. Have you tried one of our newer devices? Maybe a CC2652R can provide the solution you need.

Regards,
/TA

For R1, I use about 1M, so if I swapped SW and R1 positions, the interrupt wouldn't receive enough current - therefore the interrupt wouldn't work anymore.

This is strange... I can make this work using a 1M resistor in my circuit.