CC2530: frame header

shahriar gholami

Intellectual 440 points

Part Number: CC2530
Other Parts Discussed in Thread: TIMAC, Z-STACK

I want to add a specific header to the first transmitted frame from all nodes. How can I do that???

over 7 years ago

0 Toby over 7 years ago

TI__Mastermind 35070 points

Hi,

What firmware are you using?

Why not send it in the payload instead?
For compatibility with 802.15.4 based protocol (TIMAC, Z-Stack), I would not recommend adding to the beginning of the packet.

Regards,
Toby

0 shahriar gholami over 7 years ago in reply to Toby

Intellectual 440 points

Thank u for answer... actually I'm beginner in zegbee and now I need every ZEDs to introduce their self for the first time they join the network(something like pilot). So how do you recommend to do that??? I use z-stack3

0 Toby over 7 years ago in reply to shahriar gholami

TI__Mastermind 35070 points

When a ZED joins a network, it will broadcast a Device Announce over-the-air. Perhaps you can utilize this.

Please use the coordinator and end device examples provided in your installation of Z-Stack, and use a sniffer so you can observe the radio traffic.

0 YiKai Chen over 7 years ago in reply to shahriar gholami

Guru 735705 points

Try to refer to

Zigbee & Thread

Zigbee & Thread forum

CC2530: frame header