CC2530: WE1005 PROGRAM GUIDE

Hi! 

Thanks for the help.

Now my WE1005 module(CC2530) is working and i can upload basic program (blink) using IAR
But still i am still not able to configure it as zigbee coordinator and router

Above fig shows the my zstack page for uploaded Router firmware in one zigbee

similarly zstack page for uploaded Coordinator firmware in other zigbee

I have tried setting pan id and other parameter, but every time i restart the device reset
Have no idea what to do further

Thanks

Hi ! 

I have reffered to your link 

https://sunmaysky.blogspot.com/2015/10/setup-zigbee-ha-coordinator-with-ti.html?m=1

And i have run the script "Coordinator_light.zjs"

Now i am stuck on 5 step saying

What firmware should i use to make other zigbee cc2530 to work as end device 

Also i do not have CC2650, all i have is cc2530 10 pcs

Since you use CC2530, you can build SampleTemperature CC2530 example instead of CC2650.

I tried to build and upload sample temperature example in my cc2530 using ccdebugger .but it shows lot of errors while compiling.

is there any setting i have to change in IAR

Which Z-Stack and IAR version do you use?

I am using z stack 3.0.2

http://www.ti.com/tool/Z-STACK

and IAR 

https://www.iar.com/iar-embedded-workbench/#!?architecture=8051

free 30 days trial version

What build errors do you see?

i have uploaded the temperature sensor program successfully also  set -DDEFAULT_CHANLIST=0x00000800 (channel 11) in f8wconfig.cfgas given in the instruction.

Can't find how to set next

set "xHOLD_AUTO_START" and "xNV_RESTORE" in ZStackCore. Set "xZCL_EZMODE" in SensorTag application

i have also continued without setting the above parameters

But no success

"HOLD_AUTO_START" and "NV_RESTORE" is inside project predefined symbols of your SampleTemperature example.