CC2530: end device association not sending

armin hosseini

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK

Hi,

I'm using cc2530 and z stack sample light code I have two problems

first of all, I don't even know if I set my code to act as an end device properly but when I upload code to my module it sends beacon and my hub responses back but joining process doesn't complete and stops at this step despite sending the association and doing the rest of the joining process.

so first of all how can I be sure that I'm configuring my code for end device properly?

and why association request isn't sent?

over 6 years ago

0 YiKai Chen over 6 years ago

Guru 735685 points

Can you elaborate which Z-Stack version and example you are testing? It's better to provide sniffer log to clarify your issue.

0 armin hosseini over 6 years ago in reply to YiKai Chen

Prodigy 200 points

I'm using Z-Stack Home 1.2.2a.44539 and I'm using sample light code.

my first question clarified but still there is a problem when I'm set my code as an EndDeviceEB and uploading to my module it doesn't send any beacon but there is another type of code in the name of RouterZLight(in the same work space) this code work properly for me and joining my hub. I need my module act as an end device so I appreciate if you could help me solve my problem with end device code.

when I'm uploading code to the module sniffer shows nothing about joining process even beacon request but if you consist I can send my sniffer log.

0 YiKai Chen over 6 years ago in reply to armin hosseini

Guru 735685 points

Do you disable HOLD_AUTO_START in your end device project predefined symbols?

0 Toby over 6 years ago in reply to armin hosseini

TI__Mastermind 35020 points

Hi,

Yes, please share the sniffer log if possible.

Also, have you already looked over the Sample Application User's Guide (C:\Texas Instruments\Z-Stack Home 1.2.2a.44539\Documents\Z-Stack Home Sample Application User's Guide.pdf)?

Regards,
Toby

0 armin hosseini over 6 years ago in reply to YiKai Chen

Prodigy 200 points

no, I didn't it's still there

0 YiKai Chen over 6 years ago in reply to armin hosseini

Guru 735685 points

Remove it and test again.

0 armin hosseini over 6 years ago in reply to YiKai Chen

Prodigy 200 points

oh, I didn't mention that I deleted that symbol and my problem resolved.

thanks for your reply.

Zigbee & Thread

Zigbee & Thread forum

CC2530: end device association not sending