CC2538 Dumping the data received through RF into a file

Prabhu G1

Other Parts Discussed in Thread: Z-STACK, SMARTRFTM-STUDIO, CC2538-SW

Is it possible to dump the data that we receive on RF into a file directly or indirectly?

I want to dump the data and use it for further processing after a certain amount of time.

0 YiKai Chen over 6 years ago

Guru 735695 points

Do you use Z-Stack?

0 Ryan Brown1 over 6 years ago

If using Z-Stack then this is more complicated but you could at least log MT packets through Z-Tool.

Or you could use a sniffer device and Wireshark or Ubiqua software to filter packets destined for a specific node: https://e2e.ti.com/support/wireless-connectivity/zigbee-and-thread/f/158/t/699648

Regards,
Ryan

0 Prabhu G1 over 6 years ago in reply to YiKai Chen

I am not using Z-Stack. I am using gcc cross compiler. I want to write those into a temporary storage and read back from it for further processing.

0 YiKai Chen over 6 years ago in reply to Prabhu G1

Guru 735695 points

You can try to refer to sdcard example in CC2538-SW to use SD card as temporary storage.

Zigbee & Thread forum