LAUNCHXL-CC26X2R1: cc26x2r1

Dattatray Hinge

I am using LAUNCHXL-CC26X2R1 for initial development, but I am wondering how to usecJTAG in the MCU without XDS100 debuger or with thrid party debugger. Pls advice jumper setting of lunchpad to isolate XDS100 debugger.

Secondly how to switch between JTAG and cJTAG? What is default mode?

over 4 years ago

0 Ryan Brown1 over 4 years ago

TI__Guru**** 208857 points

Hi Dattatray,

Have you seen the "Advanced use of the LaunchPad hardware" section of the LP User Guide? http://dev.ti.com/tirex/explore/node?node=AEkWQJzOeou7V3Syra6w9w__FUz-xrs__LATEST

You can use the .ccxml target configuration file -> Advanced Setup -> Target Configuration of the CCS project to change JTAG modes (cJTAG is default) http://software-dl.ti.com/ccs/esd/documents/ccs_custom_target_config.html

Regards,
Ryan

0 YiKai Chen over 4 years ago

Guru 735515 points

As I know, CC26x2R1 doesn’t embed XDS debugger. You have to use XDS110 on LaunchPad or external debugger for development.

0 Dattatray Hinge over 4 years ago in reply to YiKai Chen

Expert 1090 points

Yes, XDS110 is on Lunchpad

0 Dattatray Hinge over 4 years ago in reply to Ryan Brown1

Expert 1090 points

Can get the protocol details of cJTAG, basically I am reversing protocol used in cJTAG.

If possible please share cJTAG protocol details

0 YiKai Chen over 4 years ago in reply to Dattatray Hinge

Guru 735515 points

You can refer to screenshots in https://sunmaysky.blogspot.com/2016/06/?m=1 to switch Jtag/cJtag in CCS.

0 Ryan Brown1 over 4 years ago in reply to Dattatray Hinge

TI__Guru**** 208857 points

https://software-dl.ti.com/ccs/esd/documents/xdsdebugprobes/emu_xds110.html
http://dev.ti.com/tirex/explore/node?node=ALPj8d4nExk6OFqlyytqKw__FUz-xrs__LATEST

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

LAUNCHXL-CC26X2R1: cc26x2r1