Disabling the PA amplifier for CC1352P2 launchpad in ZNP project

albgarc2014

Genius 3470 points

Other Parts Discussed in Thread: SYSCONFIG, Z-STACK

Hi TI!

How to disable the PA amplifier for CC1352P2 launchpad in ZNP project?

Maybe I must to remove the predefined symbol CONFIG_PA_TYPE=APIMAC_HIGH_PA?

Thank you very much. Best Rgerds.

over 4 years ago

0 Ryan Brown1 over 4 years ago

TI__Guru**** 208997 points

Hi albgarc,

Open the SysConfig file of your project and go to Z-Stack -> Radio Trasmit Power, by selecting a value of five or lower you will disable High PA operation. These instructions are also provided in the Z-Stack User's Guide.

Regards,
Ryan

0 albgarc2014 over 4 years ago in reply to Ryan Brown1

Genius 3470 points

Hi Ryan,

Sincerely, Thank you very much.

Best Regards.

Zigbee & Thread

Zigbee & Thread forum

Disabling the PA amplifier for CC1352P2 launchpad in ZNP project