Frequent Questions

  • [FAQ] BQ25600: What is ship mode and how do I enter and exit it in BQ2560x?

    Part Number: BQ25600 Other Parts Discussed in Thread: BQ25601 , Tool/software: The I2C programmable BQ2560x has a mode to minimize quiescent current for the BQ25601/D and BQ25600/C/D from the battery in cases when the system load is not needed to be powered…

  • [FAQ] BQ25600: How do I set the temperature range I desire using the TS pin on BQ2560x?

    Part Number: BQ25600 Tool/software: The BQ2560x TS pin (excluding BQ25600C) is used to monitor the battery temperature via a thermistor with a pull-up and pull-down resistor. As the two resistors represent two unknowns when designing the TS circuit, only…

  • [FAQ] PGA900: How do I launch a debug session in CCS?

    Part Number: PGA900 Other Parts Discussed in Thread: PGA970 Tool/software: I am writing firmware for PGA900/970. I am trying to launch a debug session so I can debug my firmware. How do I launch the session properly?

  • [FAQ] TMS320C6678: Steps to generate a btbl file from .out using Hex6x Utility?

    Part Number: TMS320C6678 Tool/software: Hi Team, Could you explain the steps to generate a btbl file from .out? Regards, Betsy Varughese

  • [FAQ] PGA970: Is there general information and guidance regarding the PGA970?

    Part Number: PGA970 Other Parts Discussed in Thread: PGA900 Tool/software: I'm having some issues and need some guidance regarding the PGA970. What information is available?

  • [FAQ] PGA900: How do I setup my debug configuration in CCS?

    Part Number: PGA900 Other Parts Discussed in Thread: PGA970 , Tool/software: I have firmware I want to debug for PGA900 or PGA970? How do I setup my debug configuration in CCS?

  • [FAQ] PGA900: I am having trouble compiling my code in CCS

    Part Number: PGA900 Other Parts Discussed in Thread: PGA970 , Tool/software: I am trying to build firmware in CCS for use with PGA900 or PGA970. I am running into errors while compiling my code. What is going wrong?

  • [FAQ] J721S2XSOMXEVM: TDA4VL: How to toggle user LEDs on CPB board?

    Part Number: J721S2XSOMXEVM Tool/software: There are two user LEDs on the J721S2 EVM. How to toggle them?

  • [FAQ] RM44L520: Building HALCoGen-generated code with Clang (Issues, successful workarounds, proposed upstream fixes)

    Part Number: RM44L520 Other Parts Discussed in Thread: HALCOGEN Tool/software: I have been using Clang/LLVM, specifically ARM's ATfE distribution , to compile HALCoGen-generated code. It mostly works great, but there are a few issues that have to…

  • [FAQ] DRV8000-Q1: [FAQ] DRV Motor Drives GUI Scripting Feature

    Part Number: DRV8000-Q1 Tool/software: FAQ: How to use the Scripting Window in an EVM GUI Recent EVM GUI’s include a new feature called the Scripting Window. You can access this by clicking Tools, Scripting Window from any page in the GUI after…

View FAQ threads