Part Number: AM623
Hi, TI Expert
[Problem] : We found "MCU_OSC0_XI/MCU_OSC0_OUT" clock starts timing "forward" than VDD_CORE voltage pull high. (Customized board)
Normal timing should be like this chart.
MCU_OSC0_XI/MCU_OSC0_OUT starts after VDD_CORE…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM64B , SK-AM62B
Overview
The UART boot mode available on AM6x processors (and other similar TI devices) is a valuable tool often used during development and board bringup. To load the initial…
Part Number: AM62A7
Hello.
I'm developing custom board which has RMII connection with Ethernet Switch IC. The AM62A and the Ethernet switch IC are connected via MAC-to-MAC mode. The message 'eth0 Link is up' appears, but the ping command fails. I…
Part Number: TDP1204
Brief Overview of HDMI PHY:
The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
Part Number: TMUX1574
S-parameter (or scatter parameter) models are AC based models used to understand small scale AC performance of devices. They are created by measuring the scattering (reflections and transmissions) of a device based on some stimulus…
Part Number: DP83869
Hi Ethernet Team ,
I have a question on the Xi clock input level.
The DP83869 EPHY IO supply is 3.3V
The Clock buffer supply is 1.8V.
Based on the below, looks like this should not be a issue. Any thoughts please.
Regards…
Part Number: PROCESSOR-SDK-AM62A Other Parts Discussed in Thread: AM62A74 , AM68A , AM62A3 , AM69A I made a model and what to understand how fast it can run on an AI accelerated device like the AM62A.
I see variations in performance based on which scripts…