Frequent Questions

  • [FAQ] AWR1642: Maximum Range, Range Resolution in Obstacle Detection Demo

    Part Number: AWR1642 This thread provides information about how to compute the maximum range and range resolution based on the chirp configuration provided in the Obstacle Detection Lab provided in the Automotive Toolbox "mmwave_automotive_toolbox\labs…

  • [FAQ] TLV320AIC CODECs: CODEC Control Foreign Language Installation Challenges

    Hello, After installing CODEC Control SW and selecting the EVM board this error pop-up is displayed on my screen. What should we do?

  • [FAQ] Can I leave "...." pin floating on my I2C I/O expander or I2C switch? (INT, Reset, Port I/O, ect.)

    For I2C I/O expanders and switches, what happens if I leave a pin floating (such as an interrupt pin, Reset pin, I/O pin, ect.)?

  • [FAQ] AWR1843: Where can I find the source code for the mmWave Demo Visualizer

    Part Number: AWR1843 Go to https://dev.ti.com/ , select "Gallery" In the mmWave Demo Visualizer Window Click on the download Icon and select platform to download. After downloading, unzip "mmWave_Demo_Visualizer_3.1.0_installer_win.zip" If we…

  • [FAQ] SN65DSI86: Can DSI86 support 4k2k 60Hz?

    Part Number: SN65DSI86 I have a eDP panel which supports 3840 x 2160 at 60Hz 24bpp resolution. Can the DSI86 support this resolution?

  • [FAQ] Selecting the Best IDRIVE setting and Why this is Essential

    Using the wrong IDRIVE setting can damage your FET or DRV as it often causes excessive ringing and/or cross-conduction when the Gates are slammed on or off too strongly. This document discusses the methods and some Do's and Don'ts IDRIVE Do's and Don…

  • [FAQ] LM3697: How to configure it to light up my LEDs? Any user guide and FAQs I could take as a reference?

    Part Number: LM3697 If you are new to LM3697, what should you do to light up the LED load? where should you find the reference code? And what do these registers mean? How to configure them?

  • [FAQ] DS125DF1610: How to setup the device to generate different PRBS pattern

    Part Number: DS125DF1610 Sometimes for development/test purpose, you may want to have a 10GbE PRBS generator. How would you setup DS125DF1610 to generate these different PRBS patterns.

  • [FAQ] CCS: How to resolve build error #10234-D: unresolved symbols remain?

    Tool/software: Code Composer Studio I am getting a build error from the linker when building my CCS project: error #10234-D: unresolved symbols remain How do I resolve it?

  • [FAQ] MSP-EM-DESIGN-CENTER: Can the Energy Measurement Design Center (EMDC) measure DC voltages and currents?

    Part Number: MSP-EM-DESIGN-CENTER Other Parts Discussed in Thread: EVM430-I2040S Hello everyone, This question came up recently, so I wanted to provide some guidance in case others had the same question. Currently, EMDC supports AC RMS and peak measurements…

View FAQ threads