Frequent Questions

  • [FAQ] TDA4x: When bringing up CSI-RX, what order do I need to enable components in?

    Part Number: TDA4VH-Q1 I have a camera, serializer, and deserializer, and I'm trying to capture video on CSI-RX. What order do I need to enable the devices in?

  • [FAQ] TIDA-050026-23881: Dynamic Power Management - Expected Behaviors

    Part Number: TIDA-050026-23881 One of the main challenges of designing a multi-port system is supporting all ports on a full load using a limited power supply. TI’s FirmPSE system-level firmware solution provides designers with various power supply…

  • [FAQ] AM263P4-Q1: How to run FLS SIP examples in AM263P SIP Device?

    Part Number: AM263P4-Q1 Please provide the steps to run FLS SIP examples on AM263P SIP Device

  • [FAQ] TDA4VH-Q1: How to get Traffic profile for c7x core using cp trace

    Part Number: TDA4VH-Q1 Hi Team, Could you guide me on the steps to get the traffic profile for c7x cores using cp trace?

  • [FAQ] TDA4VH-Q1: How to Pass VLAN 0 Packets Transparently Through CPSW Using the Native Linux Driver

    Part Number: TDA4VH-Q1 By default, CPSW does not pass VID 0 (priority-tagged) frames as-is. The Linux driver strips or replaces VID 0 at both ingress and egress, making it impossible for the use-cases that require VID 0 with priority bits set on the…

  • [FAQ] TMS320F28P650DK: Ethercat Important Documentation.

    Part Number: TMS320F28P650DK Understanding Ethercat: Introduction to Ethercat by Beckhoff : EtherCAT Introduction ETG.2200 EtherCAT, EtherCAT P and Safety over EtherCAT Slave Implementation Guide Section I - Technology Register Description…

  • [FAQ] AM263P4-Q1: What is the difference between sbl_can_multicore_elf and sbl_can_uniflash_multicore_elf? How to flash an application via can into external flash

    Part Number: AM263P4-Q1 Other Parts Discussed in Thread: UNIFLASH

  • [FAQ] AM62P: McASP on MCU-R5F Core (mcu-r5fss0-0) — AM62Px MCU+ SDK

    Part Number: AM62P Other Parts Discussed in Thread: SYSCONFIG The AM62P MCU+ SDK only provides McASP examples for the wkup-r5fss0-0 core. How do I port McASP to run on the mcu-r5fss0-0 core with DMA support on the AM62Px platform?

  • [FAQ] MSPM0-SDK: [FAQ] MSPM0C1104/MSPM0G3507: Software Uart example

    Part Number: MSPM0-SDK Other Parts Discussed in Thread: MSPM0C1104 , MSPM0G3507 Small-package MSPM0 devices often run into hardware UART count limitations due to pin constraints. When you need more serial interfaces than the on-chip UART modules can…

  • [FAQ] LMx518x: What are the different products in LMx518x family and how they differ?

    Part Number: LM5180-Q1 Other Parts Discussed in Thread: LM25180 , LM5180 , LM25185 , LM5185 , LM5181 , LM25183 , LM25184 If you are going for PSR Flyback topology for power requirement of 1W to 50W, you can take these LMx518x devices into your design…

View FAQ threads