Part Number: BQ25600 Other Parts Discussed in Thread: BQ25601 Tool/software: The /QON pin has multiple functions on the BQ25601/D and BQ25600/D and is pulled up internally. The only thing connected to this pin should be some switch/FET/button etc. Float…
Part Number: BQ25600 Other Parts Discussed in Thread: BQ25606 , , BQ25601 Tool/software: When a fault occurs on BQ2560x (excluding BQ25606) an /INT pulse is sent to the host. For the BQ25601/D and BQ25600/C/D the fault statuses in REG0x09 are kept static…
Part Number: BQ25600 Other Parts Discussed in Thread: BQ25601 , Tool/software: The I2C programmable BQ2560x has a mode to minimize quiescent current for the BQ25601/D and BQ25600/C/D from the battery in cases when the system load is not needed to be powered…
Part Number: BQ25600 Tool/software: The BQ2560x TS pin (excluding BQ25600C) is used to monitor the battery temperature via a thermistor with a pull-up and pull-down resistor. As the two resistors represent two unknowns when designing the TS circuit, only…
Part Number: PGA900 Other Parts Discussed in Thread: PGA970 Tool/software: I am writing firmware for PGA900/970. I am trying to launch a debug session so I can debug my firmware. How do I launch the session properly?
Part Number: PGA970 Other Parts Discussed in Thread: PGA900 Tool/software: I'm having some issues and need some guidance regarding the PGA970. What information is available?
Part Number: PGA900 Other Parts Discussed in Thread: PGA970 , Tool/software: I have firmware I want to debug for PGA900 or PGA970? How do I setup my debug configuration in CCS?
Part Number: PGA900 Other Parts Discussed in Thread: PGA970 , Tool/software: I am trying to build firmware in CCS for use with PGA900 or PGA970. I am running into errors while compiling my code. What is going wrong?
