Hi Jack,
What is your INCLK and operating mode? What is the timing relationship between this 16 MHz clock for your CIS and INCLK?
Can you please share your CIS sensor datasheet and identify the clock signal you need?
Regards,
Hooman
Hi Brad,
The attached TINA-TI file shows the right gain (~+10V/V) with 100ohm output load. It must be that your 8ohm speaker is too low for this device to drive directly and you may have to raise that impedance or otherwise add more output current to…
Hi Daesung,
We have come to find out that one of the files within the LMX9838-sw is corrupt. I'm talking about the zip file that you get when you click here:
For example, when you try the SBC_FCC.dir tests shown below, you would not be able to…
Hello All,
Here are the replacements I recommend. You should consult the datasheets in every case just to make sure:
1. OPA354 (single), OPA357 (single with disable), OPA2354 (dual).
2. LMH6702, LMH6703, OPA695, THS3201.
3. LMP8672, OPA1602, MC33078…
Hello Samir and Mickey,
You could also consider the LMH6624 / LMH6626 which says the following on its front page:
" Improved Replacement for the CLC425 (LMH6624)"
Regards,
Hooman
Hi Jigar,
You had also posed the following question I had forgotten to respond:
"For high frequency signal, diode's capacitance comes in picture. How can i calculate diode capacitance for 5MHz signal?"
The diode capacitance is a function of applied…
Hi Matthew,
Sorry I did not explain better.
By "2Vbe" I mean 2 diode drops (or about 2x0.6= 1.2V). That's what forward biases the diodes. Any less than that, and the diodes would not be able to conduct / forward-bias. This is the "differential" input…
Hi Noel,
I know that you've looked at some of my older posts and had questions. I am in a time crunch right now and may or may not be able to chime-in in the near future.
However, I do recommend that you upload the TINA-TI files (I could not see it…
