The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] Choosing the right audio op amps in context

    Choosing the right audio op amp in different contexts: Parts discussed in this thread: OPA167x , OPAx134 , OPA165x , OPA1622 , OPA160x , OPA1692 , OPA1611 , OPA1632 , With so many different audio op amps available from TI, it can be difficult to determine which one…

  • [FAQ] Understanding the parameters for audio op amps

    Understanding Key Parameters for Audio Operational Amplifiers There are a number of design considerations to take into account when designing your audio system. When choosing the right audio amp, here are some of the most important parameters to keep…

  • [FAQ] Understanding the parameters and architecture of speaker amplifiers

    Types of Speaker Amplifiers This section will focus on speaker amplifiers and understanding the parameters that go into each device. There are many different kinds of audio amplifiers. When most people think of audio amplifiers, they think of speaker…

  • [FAQ] Functional Safety for Precision Amplifiers

    What is functional safety? Functional safety standards like International Electrotechnical Commission (IEC) 615081 and International Organization for Standardization (ISO) 262622 require that semiconductor device manufacturers address both systematic…

  • [FAQ] Selecting low cost amplifiers for battery testers

    Other Parts Discussed in Thread: TLV9162 , TLV9152 Battery test applications require voltage accuracy of 0.01% or 100 ppm of the full-scale range after system calibration. General-purpose amplifiers with 1 µV/ °C input offset drift can easily meet…

  • [FAQ] INA190: How Can I Calculate Total Power Consumption of My Current Sensing Amplifier?

    Part Number: INA190 When creating a power budget in an electrical design, it’s important to know how much power can be consumed by every device in the design. Current sensors have several power consumption components, some higher than others, that should…

  • [FAQ] LM358: In a multiple amplifier package, what do I do with any unused amplifiers?

    Part Number: LM358 If your design uses a multiple amplifier package (dual, quad) you may find that some amplifiers are unused. What should you do in this scenario

  • [FAQ] How to Find In-Stock Alternative Parts

    Finding in-stock alternatives for devices has become a hot topic in this supply-constrained market. In many cases, one device may be out of stock, but there is an equally suitable device with thousands or millions of units available to immediately support…

  • [FAQ] Why does the slew rate in my application not match the op amp’s data sheet?

    Other Parts Discussed in Thread: TS321 , TL074 , TLV9001 , OPA4991 , OPA2991 , OPA991 , LMV831 , OPA345 , LMV821-N , OPA377-Q1 , OPA376-Q1 , OPA377 , OPA376 , TLV376 , TLV9002 The slew rate in my application is slower than the value stated in the data sheet of the op…

  • [FAQ] Documents about Op Amp stability

    Hello, I am looking for the full Tim Green's 15-part series on Operational Amplifier Stability, that it is mentioned in "The Signal" compendium. Is the entire series available? Thanks. Massimo

View FAQ threads