Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] [H] Frequently Asked Questions - High Speed & Signal Conditioning Amplifiers Selection Guide -INAs/PGAs

    Frequently Asked Questions: Amplifiers >> High Speed Amplifiers >> HSCA Selection Guide >> Instrumentation & Programmable Gain Amplifier Selection Guide JFET Input Bipolar Input CMOS Input FDAS Power Amps …

  • [FAQ] XTR105: XTR105: Calculating Rg & Rlin

    Part Number: XTR105 Hello, Do resources exist to calculate Rg and Rlin1/Rlin2 for 2-wire and 3-wire configurations? All the best, Carolina

  • [FAQ] LOG200: Output oscillation

    Part Number: LOG200 Hi All, I have a question regarding the LOG200. The output is oscillating on a customer's circuit board, and I am seeking your assistance. The circuit board situation is as follows: A PD in a completely dark state is connected…

  • [FAQ] INA241 vs INA296: Selecting Devices with or without PWM Rejection

    Part Number: INA241A I am looking for a high voltage, precise current sense amplifier and both the INA241 and the INA296 families meet my design requirements. I see that the INA241 has a PWM reject feature like the INA750 and INA790. How do I decide…

  • [FAQ] INA240: What are the INA240 Schematic and Design recommendations?

    Part Number: INA240 What Size Resistors should be used with the INA240? Can a voltage divider be used to drive the reference input of the INA240? Why does the output of the INA240 seem distorted compared to the measured current?

  • [FAQ] INA181: How do I properly design an input filter for my INA18x-Q1 device?

    Part Number: INA181 Other Parts Discussed in Thread: INA180 , INA240 How do I properly design an input filter for my INA18x-Q1 device?

  • [FAQ] How to use the ALERT pin of a digital power monitor

    Part Number: INA236 Other Parts Discussed in Thread: INA3221 , INA209 , , INA228 , INA237 I want to use the ALERT pin of a digital power monitor, what should I pay attention to?

  • [FAQ] INA228: Current not reading as expected

    Part Number: INA228 Other Parts Discussed in Thread: SYSCONFIG I’m reading the current register value, but the result is wrong. Why am I not reading the value that I expect to be reading?

  • [FAQ] INA238: Troubleshooting I2C Communication Failures (NACK) in TI Current Sense Power Monitors

    Part Number: INA238 Other Parts Discussed in Thread: PCA9306 , TCA9517 I’m getting a “no acknowledge” (NACK) when I try to communicate with the power monitor.

  • [FAQ] INA229: Registers are reading incorrectly

    Part Number: INA229 Other Parts Discussed in Thread: INA239 Why is it when I try reading a register, it appears that I'm actually reading a completely different register? For example, I read 0x3F but I get the results from register 0x3E instead.

View FAQ threads