Part Number: ADS1294 Other Parts Discussed in Thread: ADS1296 , ADS1296R , Dear Sirs!
It is not clear to me what shall I do with pins
1A, 1B, 1C, 1D, 2A, 2B, 2C, 2D (IN5P - IN8P, IN5N-IN8N) of ADS1294. BGA case.
From one side these channels are…
Part Number: TLV320AIC3254EVM-K Other Parts Discussed in Thread: TLV320AIC3204 , TPA2012D2EVM , TLV320AIC3254 Tool/software: Hi,
I have a TLV320AIC3204_54_RHB_EVM board and the codec is TLV320AIC3254. I also have a TPA2012D2EVM and a 8 ohm/1.5w two…
Hi,
chen chen said: How do you determine the values of 17 and 20?
This is from the Schematic, we have GPIO hogs for the reset of Expansion connector.
chen chen said: After specifying the main port(1,8), I found that the other three cpsw0_phy_gmii_sel…
Part Number: BQ27542EVM Other Parts Discussed in Thread: BQ27542-G1 Our customer found SOC jumps from 8% from 0% suddenly during room temperature discharging, and the voltage at 5% (host system shutdown) is different at diffrent cycles.
All batteries…
Part Number: TPS54308
Hi Experts,
Good day!
Regarding the datasheet for TPS54308, Figure 8-1 on page 13 says: 5-V, 3-A Reference Design, but in the figure it says VOUT=3.3V.
Could you confirm that the values in that reference design are for 3…
Part Number: MMWCAS-DSP-EVM Other Parts Discussed in Thread: MMWCAS-RF-EVM , TDA2 Hello,
In our lab, we have the MMWCAS-DSP-EVM and MMWCAS-RF-EVM, likely acquired a couple of years ago. Despite being available, no one has successfully utilized them…
Part Number: LP5912-Q1 Hi,
Good Day.
In the datasheet for this part, it states on Page 5 that the dropout voltage is not a valid condition for output voltages below 1.6V. Since this part is a fixed output LDO of 1.1V, what does this note mean? …
Part Number: TDA4VH-Q1
Neither J784S4XEVM , J721EXENETXPANEVM nor BeagleBone® AI-64 does support higher than 1 Gb.
Is there any EVM supporting 5/10 Gb ethernet?
Regards, Bernd
Part Number: 14-24-LOGIC-EVM Hi Experts,
Our customer needs the dimensions or a 3D model for this part here 14-24-LOGIC-EVM. They are looking for the complete dimensions of this component so they can create the 3D model. Or if you have a 3D…