Part Number: ADC-TEMP-SENSOR-FW Hi ,
I want to setup debug environment using TI EVM board. It detects Firmware update required, but when I click on load firmware, it will prompt for upgrade failure and ultimately no PAMB controller detected. Causing…
Part Number: ADS1260 Customer found an abnormal behavior on the register value of temperature sensor at 25degree ambient temp during operation. Here is reading value.
Register value: 14000
Temp value: -59.6degree
Hi Luke,
Thank you the fast answer! I have a couple of questions just to clarify the issue here.
(1) You mentioned that you do some tests. What results did you get when trying to debug the temp sensor adc value using the debbuger? Did you try the UART…
Part Number: ADS124S08 Hello Expert,
Our customer is evaluatiing and debugging.
We want to read the values for the internal temperature sensor measurement and (AVDD – AVSS) / 4 measurement of SYS_MON[2:0] respectively.
If there is a reference source…
Thanks Luke for all your quick help. The temp sensor seems to be working well now! I've also implemented the ADC calibration values, though it seems to have skewed the results a bit more than before. Though I need to do more work on whether it is coming…
Part Number: AMC6821 Other Parts Discussed in Thread: LM94 Hi, Support Team
Do we have 1 PWM for Fan speed control, and 4 remote temp sensor solution?
if any suggestion, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: TMP139 Hi Team,
my customer is searching for a temp sensor for DDR5.
spec as below: Vddsp, 1.8V typical, 1.7-1.98V, Vddio 1V typical, 0.95-1.05V, 1MHz I2C and 12.5MHz I3C, 11bit valid data. cover -40~125C. Is TMP139 the most suitable one…
Hi Szymon,
Szymon Cmiel said: I see that VCCAD should be from 3V to 5.25V and ADREFHI can be from VSSAD to VCCAD.
Sorry my bad. you are correct about this.
Szymon Cmiel said: I need to knew the lowest voltage on VREFHI at which the temperatures sensors will…
Part Number: ADS1220 Hi Experts,
Good day! I am posting this on behalf of the customer.
I use ADS1220 as ADC to assemble pressure and temperature sensor. For cost saving, I use an internal temperature sensor as a temperature source and use a MEMS bridge…
Hello Koichiro Tashiro,
I checked internally and as mentioned above, the temp sensors are placed near the anticipated hot spots of the device.
I do not have additional information that could be shared.
Regards,
Sreenivasa