Part Number: ADC104S021
Hi,
I would like to update my ADC requirements and ask for your recommendation.
Due to the design constraints of the upstream controller board, the I2C communication lines must operate at 3.3 V.
On the other hand, the…
Part Number: ADC104S021 Other Parts Discussed in Thread: ADC128S102EVM , Tool/software: Hi,
I am looking for an evaluation board for ADC104S021CIMMX/NOPB. Can I purchase the products listed at the following URL?
https://www.ti.com/jp/lit/ug/snau005…
Part Number: ADC104S021 Other Parts Discussed in Thread: ADC128S102 Tool/software: I am asking question on what the recommended cable capacitance on SPI interface to this component is. This component is connected via 3m cable and what is maximum allowed…
Hello,
I have looked into ADC104S021, and it is an automotive grade part, but there are different grades within AEC-Q100.
This devices is a grade 3, which support up to 85C. below are the temperature levels for the different grades.
OUr automotive…
Part Number: ADC104S021 Page 5 describes T_CLH as the hold time between SCLK Low (which I assume means the falling edge) to CS_N Falling Edge. The timing diagram (Figure 5, Page 7) Shows t_CLH to be the delay between the falling edge of CS_N and the rising…
Part Number: ADC104S021 I am trying to save pins in my project. One option I'm considering is to try to run the ADC104S021 without active CS_N control (either by hard tieing it to ground, tieing it to a power-up reset chip, or by tieing it to a one-shot…
Part Number: LMC7101 Other Parts Discussed in Thread: ADC104S021 , Hi TI
Circuit function: The operational amplifier (LMC7101AIM5/NOPB/SOT23-5/TI) is designed to follow the circuit to sample ADC and monitor the change of voltage.
Phenomenon: during…
It is in the 19th page of this pdf under the title "2.2.3 Isolated Voltage Measurement Using AMC1200"
I plan to use the charger for the High side power.
tiduby7a.pdf
Kris-
Thanks for getting back to me so quickly.
I am getting TXFFST != 0 in the ISR.
If I check for TXFFST==0 in the interrupt handler and just set TXFFINTCLR=1 and PIEACK.all |= 0x20 if there are still characters in the buffer without deasserting…
Part Number: ADC104S021Q-Q1 IC: ADC104S021Q-Q1 (error parameters DNL=+/-0.4，INL=-0.4...+0.3，offset error=+/-0.4. FSE=+/-0.7)
when ADC104S021Q-Q1 convert an analog singal to ADC，wo can get the typical ADC value，but how can i calculate the max /min value…
