Part Number: ADC3544 Other Parts Discussed in Thread: , ADC3644EVM Dear TI Team,
We're planning to use this ADC Part (ADC3544) in our design.
Could you please advise whether the ADC3544 device is applicable for video digitizing ?
Part Number: ADC3544
Hello, this post is in reference to a previous post " ADC3544: DDR I and Q components output same value ". I wanted to reach out once again to attempt to get the proper output from the device.
I was able to get an output with…
Part Number: ADC3544 Tool/software: Hello, I wanted to confirm if to synchronize multiple ADC3544s the sync signal has to have a specific frequency/phase. That is to say, does the sync frequency have to match the input clock frequency, be a multiple of…
Part Number: ADC3544 Tool/software: Hello, I am attempting to collect parallel complex decimated data from this device and run into a problem whenever I increase the clock frequency above 500kHz.I have posted some example output plots given the following…
Part Number: ADC3544 Hello, I am attempting to get IQ data with DDR parallel complex decimation output but the outputs are the same for both the rising and falling edge. Here is a snippet of noise data collected when interpreted as int16:
Here are…
Part Number: ADC3544 Tool/software: Hello, I am attempting to setup DDR parallel 14-bit complex decimated output so that the I and Q components are output on the rising and falling edges respectively as seen in Figure 8-30 of the datasheet. I was able…
Part Number: ADC3544 Other Parts Discussed in Thread: TSWDC155EVM Hi,
Could you recommend data capture board to evaluate ADC3544?
In the EVM guide, TSW1400 is recommended but I couldn't find how user purchase.
Thanks.
Part Number: ADC3544 Hello Team,
I know about 2 methods of measuring INL: Best straight-line INL (gives better results) and End-point INL (more realistic).
Which method is used for TI ADCs? Is there a general answer possible? ;-)
Which method is…
